whatchamacallit type electrical connector
- cowboy4996
- 430 crawler
- Posts: 66
- Joined: Tue Oct 11, 2005 5:12 pm
- Location: Prineville OR
- lurch85
- 430 crawler
- Posts: 95
- Joined: Fri Feb 01, 2013 6:11 pm
- Location: Upper Peninsula of Michigan
well.. got the new harness piece from deere. exactly the same as what I just tried from napa. I must have some sort of replacement switch? there is a plastic ridge between the two "buttons" that wont allow the connector to slide on. Any ideas?
John Deere 420C, John Deere 350 straight with Gafner loader, John Deere 4020
Cut the wires and put on two female spade terminal connectors or something very similar that will go on the terminals.
Lavoy
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
the connector is a packard 56 type they are made i a single version but may not fit side by side on your switch but you can get just the bare connectors http://www.pcsconnectors.com/2962965.aspx
2010 with 622 dozer with mod. 35 ripper and a 2010 with 622 dozer bought in 1969 and a 2010 loader with drott and mod. 36 ripper
That's the ones I was thinking of, didn't know what they were called. I have put female spades on them in the past, and it will work, just probably not as good as the correct one.
Lavoy
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
Who is online
Users browsing this forum: No registered users and 86 guests