Date of machine 450C
Bill, I would say post the pictures. I think it would do everyone good to take a look. My best guess is about 95% of the people who think they need a new head gasket on a older machine will need one only because they are about to tear down the motor and replace the sleeves. I do not think that most people spend the money to or even know to put the anti-galvantic protection additive in the radiator when they bust a hose or work on the cooling system the first time.
JAG
-
- 40C crawler
- Posts: 13
- Joined: Sat Jun 17, 2006 12:04 pm
- Location: Jacksonville, Florida
Look Good
Those sleeves look so much better than the ones that came out of mine. One sleeve would have looked like a jack-o-lantern if you put a light in it. After looking at them I could not believe that all the holes held and let go at the same time. One hole was about half the size of a small pencil eraser.
The holes will most like be in the number 3 or 2 cylinders.
The holes will most like be in the number 3 or 2 cylinders.
JAG
-
- 40C crawler
- Posts: 22
- Joined: Sat Sep 30, 2006 8:39 pm
-
- 40C crawler
- Posts: 22
- Joined: Sat Sep 30, 2006 8:39 pm
-
- 40C crawler
- Posts: 13
- Joined: Sat Jun 17, 2006 12:04 pm
- Location: Jacksonville, Florida
Who is online
Users browsing this forum: No registered users and 68 guests