pulling the eng. on a 350c

cantbeatadeere · Post by **cantbeatadeere** » Sun Sep 14, 2014 6:32 pm

Is it easier to pull the entire blade to remove the engine and change the isolation dampener, or can it be worked around to do the job??...2017 hrs...is there anything else that should be done while apart. Just bought it and put a pretty good 6 hrs of load on it and the reverser and hydraulics work perfectly. THANKS IN ADVANCE!!

---also - is it common for the crawler to sound much louder in reverse than forward(gear whine)

cantbeatadeere · Post by **cantbeatadeere** » Sun Sep 14, 2014 7:07 pm

O.K. scratch the noise going in reverse...all the ones on youtube make the same sound.

jsal · Post by **jsal** » Mon Sep 15, 2014 4:30 am

when I had to replace the spline between the reverser and transmission I removed the blade assembly made easy access.

JIM

JDcrawlers Messageboard

pulling the eng. on a 350c

pulling the eng. on a 350c

Who is online