Hydraulic Track Adjuster Ball Size

Post support questions about your JD350 and newer crawler here
Post Reply
User avatar
CuttingEdge
2010 crawler
2010 crawler
Posts: 534
Joined: Wed Sep 03, 2014 5:13 pm
Location: Maine

Hydraulic Track Adjuster Ball Size

Post by CuttingEdge » Tue May 31, 2016 5:56 pm

Anyone know the size of the Hydraulic Track Adjuster Ball so I can get a new one on a 1988 John Deere 350D? There is no size on the John Deere Parts Site.

I think that is the issue anyway. new seals on the hydraulic adjuster, new grease zerk, pushes the idler out fine, is being properly bled...but after a bit of work the lag is slack again.

I am thinking that ball got pumped out at some point? I am assuming it just drops back in the bleed screw hole?
I have no intention of traveling to my grave in a well manicured body; instead I am going to slide into heaven with a big power turn, totally wore out with busted knuckles, jump off my dozer loudly yelling, Woo Hoo, another Shepard has just arrived!

Post Reply

Who is online

Users browsing this forum: No registered users and 46 guests