450c crawler fuel solenoid wiring

Post support questions about your JD350 and newer crawler here
Post Reply
adhsue
MC crawler
MC crawler
Posts: 1
Joined: Mon Jan 26, 2015 9:30 pm
Location: missouri

450c crawler fuel solenoid wiring

Post by adhsue » Thu Mar 09, 2017 9:44 pm

So I have a 450c cranks no start unless I put 12v to fuel solenoid, Does anyone have a wiring daigram ? I replaced ign switch thinking it was bad but no help . Would like too know how its wired so I can track down open wire or relay , fuse , etc to solenoid Thanks in advance for any help
Top
User avatar
gregjo1948
350 crawler
350 crawler
Posts: 1000
Joined: Mon Aug 30, 2010 5:58 am
Location: Newark Valley,NY,USA

Post by gregjo1948 » Fri Mar 10, 2017 4:40 am

Did you connect the solenoid to a constant "hot" post on the switch? I believe the solenoid requires 12v until you want to shut the engine down. Use the switch position that would be like the "ignition" position on your car.
JD 350B diesel 6way blade, Case 580B Loader/backhoe, Farmall 504 high crop w/ flail boom mower, International 404 , International 284 diesel w/belly mower, 1972 Ford F600 dump truck, Galion 3-5 roller, Allis Chalmers D17, 1620 Ford
Top
User avatar
Stan Disbrow
350 crawler
350 crawler
Posts: 2898
Joined: Fri Jul 15, 2005 3:13 pm
Location: Raleigh, NC

Post by Stan Disbrow » Fri Mar 10, 2017 5:27 am

Hi,

Wiring is easy: from positive battery post to input of ign switch. Then wire from Run terminal of ign switch to fuel solenoid.

Stan
There's No Such Thing As A Cheap Crawler!

Useta Have: '58 JD 420c 5-roller w/62 inside blade
Useta Have: '78 JD350C w/6310 outside blade
Useta Have: '68 JD350, '51 Terratrac GT-25
Have: 1950 M, 2005 x495, 2008 5103 (now known as 5045D)
Top
Post Reply

Return to “Late model JD crawler technical support”

Who is online

Users browsing this forum: No registered users and 104 guests