450 steering clutch rebuild

Post support questions about your JD350 and newer crawler here
Post Reply
User avatar
thomasgranat
40C crawler
40C crawler
Posts: 12
Joined: Wed Dec 20, 2017 7:25 pm
Location: Auburn Ca

450 steering clutch rebuild

Post by thomasgranat » Sun May 20, 2018 1:52 pm

so finally got the steering clutch out. What a job. the fiber discs do not appear to have much wear but the steels are rusted pretty bad on mostly one side. I have been using electrolisys to derust them. so a couple of questions , am I being completely stupid to attempt to reuse the discs? does anybody have the dimensions of the JD 264 gage that is used to set the finger height ? I have the dana spicer clutch on a 450 straight model . Also does anybody know what the clutch pack thickness is supposed to be when new ? Thanks for your input

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests