How do the shanks fit into the slot? I have the shank the wedge and the spring, there is also a 5/16" bolt in the parts diagram. How does all this fit together to lock the shank in the slot? There are groves in the side of the shank is that supposed to fit into something? Can anyone provide some up close photos of how the shanks all locks in? Is it just a smooth slot in the ripper attachment or are there ears in there somewhere?
I'm not sure I have the 3110 base anymore as my shanks are slight larger than the slot.
Ripper shanks
Ripper shanks
JD- 450C track loader
Serial #208336T
Serial #208336T
Re: Ripper shanks
Hello,
I went to the vault and checked. No operators manual for the 3110, but I do have a era correct paper parts manual. I couldn’t determine how the shank is attached.
Keep us posted. Bruce
I went to the vault and checked. No operators manual for the 3110, but I do have a era correct paper parts manual. I couldn’t determine how the shank is attached.
Keep us posted. Bruce
Re: Ripper shanks
Just bought one. I have pdf of om-u17207 John Deere 3100 and 3110 operators manual if you tell where to send it. How do you attach pictures here? Machine is supposed to be hauled in this weekend.
Re: Ripper shanks
I sent you a message with my email to send a copy of the PDF too if you have a chance.
To post pictures here is a link to the instructions:
viewtopic.php?f=5&t=13015
To post pictures here is a link to the instructions:
viewtopic.php?f=5&t=13015
JD- 450C track loader
Serial #208336T
Serial #208336T
Who is online
Users browsing this forum: No registered users and 72 guests