Very good point! I was literally just getting ready to start adding all the fluids. Will do the water leak check. I've always done that in the past but it totally skipped my mind this time around, the leak check will be important, especially putting COOL-GARD in, thanks for the reminder!
Yesterday was all about finishing up the ether injection instal including this mod https://www.youtube.com/watch?v=tExPo62gCa8 along with new 1/8" line, new 90* compression fitting and new adapter fitting coming out of the operator port. The 90* 1/8" compression fitting I bought came with no compression ferrule/sleeve so I had to go to town for a 20c piece lol. Why would JD sell a compression fitting without a ferrule is beyond me, that's pointless?
Also, I had to get the entire wiring harness correctly routed (which meant relentlessly disconnecting and re-connecting everything multiple times), getting the harness all cleaned up in conduit, cable tied to their route through the machine and all that... I must say, it looks super clean for a bulldozer!