Heads off and in shop for service while i'm waiting for that i figured i would clean up valve train make sure no plugs in rockers and such . In the manual it calls for the oil holes on the rocker shaft to be faced down . The rocker shaft has 2 sets of holes flared and and non flared i would like to think the flare would be up but when i took it apart they were down . The manual doesn't show it very well so i figured i would better ask he wasen't real sure either. Not sure if its a newbie question or not for i spoke with a friend who is a mechanic and went to school for diesels but far from an expert with these machines . Any pointers would be greatly appreciated .
JD 350
ser#070582T
motor type
MU31F 3152
ser#106008T
Rocker Shaft Installation JD 350
Re: Rocker Shaft Installation JD 350
Your rocker shaft goes on with the bevel holes to the bottom.
40 plus years working on JD 350s, 400Gs, 450s and other equipment both Ag and Construction.
Who is online
Users browsing this forum: No registered users and 38 guests