Hello
I have been looking for a used factory ROPS for my 1970 350 Crawler without much luck so I am plannig to fabricate one. Would anyone who has a factory ROPS be able to provide me with some rough dimensions?
1. Tubing Diameter of main ROPS framing
2. Tubing Diameter of Limb Risers
3. Wire mesh size
4. An overall inside clear height, either from top of seat to u/s of canopy, top of armrest to u/s of canopy or side floorboards to u/s
Thank you very much in advance for any help
Jeff Vandrish
350 ROPS
Re: 350 ROPS
Jeff mine is a 1967 350 with a logging pkg. Which I assume is original. My tube is 2- 3/8 in O.D. on the cage and risers. I have 35-1/2" from the top of the arm rest steel to the underside. Mesh is 2" square openings using 1/4" dia. wire. There is a smaller mesh mounted over it but I think it was added by a previous owner..
Re: 350 ROPS
Good Morning
Thank you very much!! Greatly appreciated.
Jeff Vandrish
Thank you very much!! Greatly appreciated.
Jeff Vandrish
Who is online
Users browsing this forum: No registered users and 172 guests