Post support questions about your JD350 and newer crawler here
-
gerald
- 440 crawler
- Posts: 225
- Joined: Fri Aug 13, 2010 9:32 am
- Location: elephant Butt nm
Post
by gerald » Thu Feb 24, 2011 11:42 pm
What way should the white Teflon seal go into the track adjuster houseing ? One side of the seal has rim an the other has taper .I'm thinking the rim side should be faceing the grease end an tapper end pushing up on the ram with 0 ring on it. It was in peaces when I took it apart. It fits either way but only one way is right. My service manual really don't say much about the track adjuster rebuild. Thank you gerald.
1970 350 crawer/loader 93a back hoe
-
digitup2
- 350 crawler
- Posts: 858
- Joined: Tue Feb 05, 2008 6:36 pm
Post
by digitup2 » Fri Feb 25, 2011 9:16 am
Actually Gerald the taper or lip side goes toward the pressure of the grease and the flat side goes toward the out side .Take a fine sand paper and go length ways only to smooth the shaft and clean up all rust then install some grease to let seal slide on shaft .Digitup.
-
gerald
- 440 crawler
- Posts: 225
- Joined: Fri Aug 13, 2010 9:32 am
- Location: elephant Butt nm
Post
by gerald » Fri Feb 25, 2011 9:32 am
Thank you Digup2. I'll pull it out check the direction . I used my cordless drill on low speed with a round drum sandpapper that fit snug inside bore to clean it up, it was't bad .
1970 350 crawer/loader 93a back hoe
Who is online
Users browsing this forum: No registered users and 171 guests