350 final drive

Post support questions about your JD350 and newer crawler here
Post Reply
User avatar
meadova
40C crawler
40C crawler
Posts: 21
Joined: Fri Apr 28, 2006 7:30 pm
Location: SouthWest Virginia

350 final drive

Post by meadova » Sat May 06, 2006 9:42 pm

Could anyone tell me if the gear on the axle shaft is a press fit.

Thanks.

derbycrawler
420 crawler
420 crawler
Posts: 25
Joined: Sun Apr 10, 2005 12:36 am
Location: Mystic,Iowa

Post by derbycrawler » Sun May 07, 2006 8:24 am

No they are not a press fit.

Shannon

User avatar
meadova
40C crawler
40C crawler
Posts: 21
Joined: Fri Apr 28, 2006 7:30 pm
Location: SouthWest Virginia

350 final

Post by meadova » Sun May 07, 2006 9:54 am

How much movement should be between shaft and gear. I need some parts know anywhere to find them.
Thanks

User avatar
Lavoy
Site Admin
Site Admin
Posts: 10937
Joined: Sun Apr 03, 2005 8:32 pm
Location: North Dakota
Contact:

Post by Lavoy » Sun May 07, 2006 10:11 am

What parts do you need? I have some new parts for 350, might be able to get some used.
Lavoy

User avatar
meadova
40C crawler
40C crawler
Posts: 21
Joined: Fri Apr 28, 2006 7:30 pm
Location: SouthWest Virginia

350 final

Post by meadova » Sun May 07, 2006 10:24 am

I need brake drum and maybe the axle shaft. I'm also trying to find a complete final drive bearing and seal kit. Gulfsouth has it for $360.00 but I could do it chepaer if I could cross the JD numbers.

User avatar
Lavoy
Site Admin
Site Admin
Posts: 10937
Joined: Sun Apr 03, 2005 8:32 pm
Location: North Dakota
Contact:

Post by Lavoy » Sun May 07, 2006 2:36 pm

Bearing kit price doesn't sound too bad. You might be suprised at an outside suppliers price, they may not beat the dealer as bad as you think.
Lavoy

derbycrawler
420 crawler
420 crawler
Posts: 25
Joined: Sun Apr 10, 2005 12:36 am
Location: Mystic,Iowa

Post by derbycrawler » Mon May 08, 2006 12:08 am

Just food for thought, make sure you are getting the same spline shaft as the spline on your bull gear. I have a parts machine and went to enter- change the finals, bull gear and pinion, and the shaft and other bull gear were a different spline. They changed the splines from the early models to a different spline count in the later models. The spacers in between the bull gear are what take up all your movement so you should have very little movement if any on your bull gear. That is if I remember correctly!

Shannon

User avatar
meadova
40C crawler
40C crawler
Posts: 21
Joined: Fri Apr 28, 2006 7:30 pm
Location: SouthWest Virginia

350 parts

Post by meadova » Mon May 08, 2006 5:44 pm

Lavoy, I need a brake drum for my 350 bad, used is ok. can you help

thanks I found it ed a CH

Post Reply

Who is online

Users browsing this forum: No registered users and 38 guests