I am working some JD hydraulic cylinders would like to purchases a large parallel
snap ring plier the one I have opens to 1 1/4 inches is just a little to small to reassembly been doing internet search all I can find are the same as what I already have.even tried dealer tool websites.
HELP
JIM
parallel snap ring pliers
Don't think I have ever seen a parallel jaw one, but have seen bigger ones.
How about Snap-On, Lisle, OTC or one of the specialty tool makers?
Lavoy
How about Snap-On, Lisle, OTC or one of the specialty tool makers?
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
Found a pair of armstrong 9" #67-555 lock ring pliers that open to 1 1/2 " ordered them hope they will solve my difficulty have done three other cylinders with the parallel jaw ones but have never been able to completely
remove the lock ring have had to use a screw drive pry them off or when installing the cylinder I am working on is being a bugger!!!
remove the lock ring have had to use a screw drive pry them off or when installing the cylinder I am working on is being a bugger!!!
Those look a lot like the ones I have, but think mine are SK.
Lavoy
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
- lurch85
- 430 crawler
- Posts: 95
- Joined: Fri Feb 01, 2013 6:11 pm
- Location: Upper Peninsula of Michigan
Maybe you are already familiar with this website.. but just in case.
The style eludes me, just click on the style you want, and call if you need to know how far they open if they don't say (they've been pretty helpful in the past)
this seems to be the place if you have something hard to get, (Grade 9 fine thread left hand thread metric nut for instance), maybe not that specific, but you know what I mean.
http://www.mcmaster.com/#snap-ring-pliers/=q8dhy7
Good luck
Im assuming that the link is ok since it's not a competitor of yours, Lavoy, and that you have given suggestions yourself.
The style eludes me, just click on the style you want, and call if you need to know how far they open if they don't say (they've been pretty helpful in the past)
this seems to be the place if you have something hard to get, (Grade 9 fine thread left hand thread metric nut for instance), maybe not that specific, but you know what I mean.
http://www.mcmaster.com/#snap-ring-pliers/=q8dhy7
Good luck
Im assuming that the link is ok since it's not a competitor of yours, Lavoy, and that you have given suggestions yourself.
John Deere 420C, John Deere 350 straight with Gafner loader, John Deere 4020
Who is online
Users browsing this forum: No registered users and 69 guests