My 1962 1010 c(gas) with front end loader and rear boom

Rich Robert · Post by **Rich Robert** » Fri Oct 10, 2008 5:16 am

img]http://www.jdcrawlers.com/uploads/paint ... 9_copy.jpg[/img]

This 1010C was made in late 1962 and has Hyd. reverser, & dual hyds.
The JD810 front end loader was installed at the factory. The rear boom and three point hitch I made and installed later.

I use this rig almost daily for various jobs around our property from moving sand and gravel, to disking, raking and logging.
I have a set of forks, Old disk, and landscape rake. The rear boom is also used for raising and lowering the implements.

wwattson · Post by **wwattson** » Fri Oct 10, 2008 6:17 pm

VT350C · Post by **VT350C** » Tue Jul 24, 2012 11:28 am

wwattson wrote:

Nice rig...I love the boom. I would really like to make a boom for mine that could handle 2000 pounds...I would love to somehow work around my winch...A manual boom would be fine or run my winch through it as the cable...

Is this crazy to think like this??? Just a simple boom that goes pretty high, but not too far out...attach in 4 points somehow to frame...then run winch through it...

Bob

andregrondin · Post by **andregrondin** » Wed Jul 25, 2012 6:00 am

very nice set-up you have there !!

JDcrawlers Messageboard

My 1962 1010 c(gas) with front end loader and rear boom

My 1962 1010 c(gas) with front end loader and rear boom

Who is online