manifold paint

mgbuddydad · Post by **mgbuddydad** » Sun Apr 05, 2009 11:51 am

Is there any paint that will truly hold up over time on a two cylinder exhaust manifold ? Have a 40 that will glow dark cherry red in the dark, and these vertical 2 cylinders seem to eat manifolds.

Buddy

JD440ICD2006 · Post by **JD440ICD2006** » Sun Apr 05, 2009 2:14 pm

Want to make sure that you have the carb set correctly. If too lean, the manifold gets even hotter than normal.
As for paint, a well applied "1,200 F"should be on for a while.

Lu47Dan · Post by **Lu47Dan** » Mon Apr 06, 2009 10:01 am

Here are a some high temperature paints
http://www.por15.com/BLACK-VELVET/productinfo/BVG/

http://www.por15.com/FACTORY-MANIFOLD-G ... info/FMGG/

http://www.por15.com/POR-20-ALUMINUM/productinfo/P2G/

http://www.eastwoodco.com/shopping/prod ... ductID=733
I have not used any of them , so I can not comment on their effectiveness . Dan

Pistonman · Post by **Pistonman** » Mon Apr 06, 2009 10:01 pm

I like the look of the cast iron color heat paint, I think you can get it at NAPA.

JDcrawlers Messageboard

manifold paint

manifold paint

Who is online