Looking for a 350c final drive housing. If anyone has one please let me know. I do not know the year or serial number on this crawler. The inner shoulder that the race fits against has broken out. Could this fit be machined out and a sleeve with a shoulder be pressed in? I know it would have to be recessed on the outer edge with a shoulder on the sleeve
Barry
360c final drive housing
-
- 420 crawler
- Posts: 41
- Joined: Thu Sep 22, 2005 7:04 pm
- Location: Alabama
-
- 420 crawler
- Posts: 41
- Joined: Thu Sep 22, 2005 7:04 pm
- Location: Alabama
Left hand side sitting in the seat. I believe they are interchangable with either side. I am going to try some kind of fix. I have several ideas. May just cut a groove and put some type of lock ring for the race to seat against. I have the machines to make the repairs, just need to decide which direction to go. Need to take some measurements to make sure the fit is not out of round. It doesnt look to bad just eyeing it. Thanks for your reply.
Barry
Barry
-
- 420 crawler
- Posts: 41
- Joined: Thu Sep 22, 2005 7:04 pm
- Location: Alabama
Who is online
Users browsing this forum: No registered users and 91 guests