bad memory
- Eric.MacLeod
- 440 crawler
- Posts: 120
- Joined: Sun Feb 10, 2008 9:15 pm
- Location: wells,maine
bad memory
hello, ive put my 420 on the back burner for so long that i cant remember what these parts where for,18520,,18590,,15123,, and 15245..these are most likley for the rearend, i never could get the quills apart. im hoping that i can get away without having to take those apart because thats why i gave up on it in the first place.. thanks..Eric.
- Paul Buhler
- 350 crawler
- Posts: 991
- Joined: Wed May 21, 2008 6:25 pm
- Location: Killington, VT
Go to the john Deere web site, enter "420" for model, and down load the PC505 .pdf manual to find part numbers and parts pictures. Good luck. Paul
http://jdpc.deere.com/jdpc/servlet/com. ... ervlet_Alt
http://jdpc.deere.com/jdpc/servlet/com. ... ervlet_Alt
Paul Buhler
Killington, VT
420c 5 roll with 62 blade, FOPS, and Gearmatic 8a winch
Killington, VT
420c 5 roll with 62 blade, FOPS, and Gearmatic 8a winch
Re: bad memory
Eric.MacLeod wrote:hello, ive put my 420 on the back burner for so long that i cant remember what these parts where for,18520,,18590,,15123,, and 15245..these are most likley for the rearend, i never could get the quills apart. im hoping that i can get away without having to take those apart because thats why i gave up on it in the first place.. thanks..Eric.
When I was rebuilding mine, I almost didn't take the quills out either. It would have been a bad mistake. I found all sorts of problems there from worn linkage, no lubrication, bad seals to broken bolts. On Lavoys advise, I looked in EVERYTHING. If I hadn't, I would have been back in there after a few hours of run time.
If you're that far apart...look.
- Eric.MacLeod
- 440 crawler
- Posts: 120
- Joined: Sun Feb 10, 2008 9:15 pm
- Location: wells,maine
Who is online
Users browsing this forum: No registered users and 94 guests