General help and support for your Lindeman through 2010 John Deere crawler
-
stmftr395
- 440 crawler
- Posts: 104
- Joined: Mon Dec 11, 2006 10:21 am
- Location: Western N.Y.
Post
by stmftr395 » Sat Apr 13, 2013 5:28 pm
I have got a pin all but 5/16" or so in place in the link. Heres my issue. The flats on the pin are not exactly lined up with the flats on the link. Have tried to turn the pin. No such luck. Any body got any ideas? Your help will be greatly appreciated! Mark
1010 crawler
-
jtrichard
- 350 crawler
- Posts: 1883
- Joined: Sun Jan 11, 2009 9:48 pm
- Location: Joshua Tree CA
Post
by jtrichard » Sat Apr 13, 2013 5:31 pm
drive it back out a little while someone else has a pipe wrench on it turning it when it is lined up drive it back in
2010 with 622 dozer with mod. 35 ripper and a 2010 with 622 dozer bought in 1969 and a 2010 loader with drott and mod. 36 ripper
-
stmftr395
- 440 crawler
- Posts: 104
- Joined: Mon Dec 11, 2006 10:21 am
- Location: Western N.Y.
Post
by stmftr395 » Sat Apr 13, 2013 6:19 pm
Ok JT will give it a try. Kinda thought that might be an option, but was not sure. Thanks
1010 crawler
-
stmftr395
- 440 crawler
- Posts: 104
- Joined: Mon Dec 11, 2006 10:21 am
- Location: Western N.Y.
Post
by stmftr395 » Sun Apr 14, 2013 7:27 pm
One done one more to go. Thanks for the help JT.
1010 crawler
Who is online
Users browsing this forum: gaspumpsam and 40 guests