450E ripper keepers

Rusty0007 · Post by **Rusty0007** » Sat May 04, 2013 11:41 am

Anyone know where I could find the ripper keepers for my 450E? I have the shanks, but can only come up with two keepers. I looked on JD parts but I can't find them on there. Little wedges....

Thanks!

jtrichard · Post by **jtrichard** » Sat May 04, 2013 4:41 pm

deere #at57474 is the kit for 450b i found a pic of a 450e and looks like the same ripper shank and keeper deere is the olnly place that i know of that you can get the keepers the shanks you can get after market ... go here http://www.ebay.com/itm/John-Deere-Shan ... 0431302549 there is a pic i bought a few from this guy but looks like he sold them all but you can see if these are what you need before you go to deere.... you can look these up on jd site go to http://jdpc.deere.com/jdpc/servlet/com. ... ervlet_Alt #s 22/23/24 go to the last thing page for kit #.... do you know of any place that has those shanks used???? i need 2 would love 4

Rusty0007 · Post by **Rusty0007** » Sat May 04, 2013 8:19 pm

jtrichard wrote:deere #at57474 is the kit for 450b i found a pic of a 450e and looks like the same ripper shank and keeper deere is the olnly place that i know of that you can get the keepers the shanks you can get after market ... go here http://www.ebay.com/itm/John-Deere-Shan ... 0431302549 there is a pic i bought a few from this guy but looks like he sold them all but you can see if these are what you need before you go to deere.... you can look these up on jd site go to http://jdpc.deere.com/jdpc/servlet/com. ... ervlet_Alt #s 22/23/24 go to the last thing page for kit #.... do you know of any place that has those shanks used???? i need 2 would love 4

Thanks so much! I should have thought of looking at a previous model. I haven't run across any shanks, used anyway. I've heard there is a company in Tulsa that makes them and they are much cheaper than new ones from JD. So, I guess there is a couple different ripper models, 35, 36? How can you tell which is which? I'll keep a look out for some shanks for you....

Scottyb · Post by **Scottyb** » Sun May 05, 2013 12:11 am

I could use 2 of those shanks as well. I bought one from the dealer and would like to find 2 more at a better price!
Scottb

jtrichard · Post by **jtrichard** » Sun May 05, 2013 3:31 am

35 and 36 were used on 2010/1010 35 uses a 1 inch shank with a simple lock and narrower bar/frame and different shank spacing ...36 is 1 1/4 inch shank yours will be a 3100 or probably a 3110 they are about the same as 36 with different piston cups in the rams and i would guess wider yet again on ripper bar/frame

JDcrawlers Messageboard

450E ripper keepers

450E ripper keepers

Who is online