I've got a 420C.
I've asked quite a few question's on this site, and have gotten alot of good answer's. Thank's
Now my problem?
I drove it out of the shed yesterday, drove around some, went into the ditch.
It drove, I thought alright on the flat.
Now I can't get her to climb out of the ditch.
All the clutch component's were replaced.
I set the clutch with one of Lavoy's tool's.
I think everything went back together correctly.
It has a reverser.
The engine rev's good, but just isn't transfering the engine power to the track's.
Any thought's?
Jim
420 barely move's
If you have a PTO, put it in gear, and watch to see if the PTO shaft stops spinning when the crawler stops. If so, the problem is in the engine clutch.
Lavoy
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
Who is online
Users browsing this forum: No registered users and 75 guests