Hello everyone!
I had to rebuild the starter on my 1010 gasoline crawler loader and the masking tape label on the wire fell off. I can't remember if the wire goes to the "s" terminal or the "r" terminal. Does something attach to the opposite terminal then?
Thanks!
1010 gas starter wiring
-
- 420 crawler
- Posts: 34
- Joined: Thu Mar 27, 2014 10:23 am
- Location: south central Wisconsin
1010 gas starter wiring
Late model 1010 crawler loader
-
- 420 crawler
- Posts: 34
- Joined: Thu Mar 27, 2014 10:23 am
- Location: south central Wisconsin
no HOT START is for cars/trucks with coil/points that have an external resistor on the coil ......when your cranking it throws full 12 volts to the coil bypassing the resistor which drops the voltage to 6 volts to the coil when running..... you can put hot start on any gas engine that has a coil/points and a resistor so it starts much easier when cold it doubles the spark
2010 with 622 dozer with mod. 35 ripper and a 2010 with 622 dozer bought in 1969 and a 2010 loader with drott and mod. 36 ripper
Who is online
Users browsing this forum: No registered users and 86 guests