Post support questions about your JD350 and newer crawler here
-
1010crazy
- 420 crawler
- Posts: 29
- Joined: Mon Jul 27, 2009 5:23 pm
- Location: Minnesota
Post
by 1010crazy » Mon Nov 10, 2014 10:39 pm
I was doing a little logging today with a 450c when the winch stopped working. After a few minutes of investigation I found the coupling from the pto the winch was stripped out. Does anyone know how many splines are on the shaft. I was hoping to get a new one before I pull it apart is it the same splines as a 1000 rpm pto shaft or will I need to order from deere? Thanks in advance.
-
pondhogvt
- 440 crawler
- Posts: 121
- Joined: Sun Jul 14, 2013 2:04 pm
- Location: Johnson,Vermont
Post
by pondhogvt » Thu Nov 27, 2014 8:39 pm
I believe deere only Item part# T24774 cost $90.. here in Vermont, best of luck, Mark
350 loader,350c dozer winch and arch,450c winch and arch,450e winch and arch,D37p komatsu lgp dozer,D85 Komatsu dozer,D8k Caterpillar.
-
pop pop
- 2010 crawler
- Posts: 514
- Joined: Thu Aug 27, 2009 12:07 am
- Location: chandler, arizona
Post
by pop pop » Fri Mar 20, 2015 2:06 pm
if its the 21 spline on a 1 3/8 shaft, they are about $15 plus ship.
440icd/602/8a,,440icd/831/ripper,,440icd/831/3pt.,misc. 440 parts, i have 5 of these now, but i can stop anytime
Who is online
Users browsing this forum: No registered users and 6 guests
