350B steering control shaft bushing
350B steering control shaft bushing
while adjusting my steering controls, I have noticed that the main steering control shafts (AT31637 & 38) have a lot of slop in their movement (At least 1/4 inch). Obviously the inside bushing (PN M1638) is worn out. I think my steering control adjustment would be much improved if I could replace those. In the drawing, I notice there is a retainer clip on the end of the shaft but I haven't seen how to access it. also, is it possible to remove this shaft without tearing apart the whole steering clutch assembly?
JD 350B, IH 500E
Who is online
Users browsing this forum: No registered users and 89 guests