2010 outside push converted to 6 way

Show us pictures of your JD crawler and attachments.
Tfrank
40C crawler
40C crawler
Posts: 21
Joined: Sun Nov 02, 2014 8:17 am

Re: 2010 outside push converted to 6 way

Post by Tfrank » Mon Jun 05, 2017 11:07 am

They are 12" stroke but could have used 10". The tilt is a 6" stroke. I took the time to draw it all up in 3d cad before I built it. I used 12" but didn't like how close to the center they hit if I set them up for full stroke in both directions. The way the are now it hits full on extension but is 2inches from fully collapsed on the collapsed cylinder. I should have a mechanical stop on the blade frame at full tilt but I don't use the angle much and haven't got around to it.

2010jim
40C crawler
40C crawler
Posts: 11
Joined: Wed Jan 25, 2017 7:47 pm
Location: Leonidas michigan

Re: 2010 outside push converted to 6 way

Post by 2010jim » Wed Jun 07, 2017 3:53 pm

Thanks for the information.
Looks like I need to start planning another project.
Too many projects, not enough time

harley
MC crawler
MC crawler
Posts: 7
Joined: Mon Sep 08, 2014 3:17 pm
Location: Hot Springs

Re: 2010 outside push converted to 6 way

Post by harley » Mon Mar 19, 2018 1:43 pm

I don't seem to have any pics of your conversion could you e-mail them to me, I want to do the same to mine. Thanks
noah.williams@npmchs.com

signweld@yahoo.com
40C crawler
40C crawler
Posts: 12
Joined: Sat Jun 15, 2019 3:43 pm
Location: Westwen New York State

Re: 2010 outside push converted to 6 way

Post by signweld@yahoo.com » Tue Jul 21, 2020 1:17 pm

Hello all. I know this is a 3 tear old post, But am wondering what length stroke and pin to pin dimensions of the cylinders are. I am using this design on my own 2010.
signweld :)

Post Reply

Who is online

Users browsing this forum: No registered users and 27 guests