Picked up my crankshaft from machine shop this morning, Crank was bent 0.008 in the center, machinist straighten it and ground mains and rod journals 0.020. So now I need to order bearings, I already have everything else to put engine back together. Need to press the cam drive gear on the crankshaft tomorrow. Putting in all new intake valves in head, as there is not much meat on the head of the intakes, durn thin. The exhaust valves look good. Hopefully I don't find anything else wrong with this machine.
OH, and the cost for machine work was $100.00. Not too bad of a price!!
Have a good day
Keith
Time to rebuild 1010 engine
Who is online
Users browsing this forum: No registered users and 65 guests