I suspect one of the brass pushrod tubes is leaking around it's seal with the head. Water could be coming from block side and leaking by the head gasket, but I don't think so. Should I try to re expand the tube against its seat in the head (it is a tube that has been in the head a long time) or replace it?
Also another question. Someone has suggested using brass washers under the head bolt nuts rather than the lead washers. How about that?
Thanks much for advice.
Judd
Water Leakage BO Lindemna
Re: Water Leakage BO Lindemna
The pushrod tube(s) will need replaced. I have never used brass under the cylinder head nuts. Always used lead, for torque reasons, and they have worked well for me.
Best regards, Bruce
Best regards, Bruce
Who is online
Users browsing this forum: No registered users and 110 guests