How to contact Lavoy for parts.
How to contact Lavoy for parts.
For anyone wishing to contact me for parts, my e-mail address is postmaster@jdcrawlers.com, phone is 701-361-1006. PM's are notoriously unreliable, and will often go unreceived on your end, so PLEASE, do NOT use the private message system to contact me for parts. I do not wish to be accused of not getting back to people, but once a PM is in my outbox, I have no control over it.
It is much better to call me, or e-mail me. I hate to beat the dead horse, but I delete a lot of unreceived PM's that I have sent to people, some going back months.
Thanks,
Lavoy
It is much better to call me, or e-mail me. I hate to beat the dead horse, but I delete a lot of unreceived PM's that I have sent to people, some going back months.
Thanks,
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
Cutting edge for {Peanut} JD 350 crawler Loader
Morning Lavoy; Been awhile ; Hope all is well, Looking for a weld on cutting edge w/ curl up ends for 350 JD Loader. cutting/ bucket width is 64.5 -65in wide. Wondering if you had one or any ideas as to get one or Just go with AR plate? Thanks for any ideas.
David F Kalena Maple City Michigan 49664
David F Kalena Maple City Michigan 49664
Re: How to contact Lavoy for parts.
I don't have anything, but it is something that should be readily available so to speak. You may have to curl the ends yourself. Some steel supply houses carry cutting edge.
Lavoy
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
Re: How to contact Lavoy for parts.
Thank you for your time and responce. Appreicate it Dave
-
- MC crawler
- Posts: 2
- Joined: Sun Aug 07, 2022 9:38 pm
Re: How to contact Lavoy for parts.
Just got registered on your site. I'm restoring a 1958 420C and need at least the following:
Ring gear (32 tooth) & pinion (7 tooth)
Cluster gear (43/26/19 tooth, M4205t I think)
Final drive pinion gear
Lower roller thrust plate (1)
Lower roller grease seals (not sure how many yet, would consider new or used)
Thanks,
Larry
Ring gear (32 tooth) & pinion (7 tooth)
Cluster gear (43/26/19 tooth, M4205t I think)
Final drive pinion gear
Lower roller thrust plate (1)
Lower roller grease seals (not sure how many yet, would consider new or used)
Thanks,
Larry
Re: How to contact Lavoy for parts.
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
-
- MC crawler
- Posts: 2
- Joined: Sun Aug 07, 2022 9:38 pm
Re: How to contact Lavoy for parts.
I tried sending an email to the postmaster and it came back "undeliverable"
Re: How to contact Lavoy for parts.
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
Who is online
Users browsing this forum: No registered users and 2 guests