DEERE PARTS SPECS
-
- 1010 crawler
- Posts: 258
- Joined: Wed Sep 11, 2013 3:34 pm
- Location: Shiner, texas
DEERE PARTS SPECS
Now and then I see where someone has access to Deere parts specs or drawings. I need the drawing for a T37440 front clutch spider to recover one with a spun-out bearing. I have been unable to find a replacement and think a good machinist can bore out and re-line the bearing pocket if I can find the specs. I anyone has access to the drawings or specs or has a good one to measure please let me know.
Early 40C w/Yakima toolbar and homebuilt ripper: 350 w/6-way
Re: DEERE PARTS SPECS
If you know/have a new bearing the machinist may be able to use the bearing info to restore the pocket, it goes into.
-
- 1010 crawler
- Posts: 258
- Joined: Wed Sep 11, 2013 3:34 pm
- Location: Shiner, texas
Re: DEERE PARTS SPECS
I agree he could get the diameter but the shoulder that sets the depth is also worn down and he will need to know how deep the bearing goes.
Early 40C w/Yakima toolbar and homebuilt ripper: 350 w/6-way
Re: DEERE PARTS SPECS
Highly unlikely that information exists outside of Deere.
Lavoy
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
Who is online
Users browsing this forum: No registered users and 62 guests