1010 Crawler Loader no start after using jump box
- milesofmike
- 40C crawler
- Posts: 11
- Joined: Sun Sep 20, 2020 7:39 pm
- Location: Chattanooga, TN
1010 Crawler Loader no start after using jump box
My 1010 crawler loader was having trouble starting. I suspected a drained battery so I used a jump box. Now it won't turn over at all, but it seems to be drawing current from the battery. I suspect the voltage from the jump box was too high for the ole girl. Before I rip it apart and guess what it might be, have any of you had a similar experience and know what to check first? I'll be looking at the ignition switch first. I also read there is a resistor between the switch and starter so that will be the next thing to check, aside from wires.
196x JD 1010 Crawler Loader
Re: 1010 Crawler Loader no start after using jump box
Could it have jammed the starter drive into the ring gear. You will need to loosen and wiggle the starter; you might even need to remove and reinstall it to get it unlocked, if that is what has happened.
- milesofmike
- 40C crawler
- Posts: 11
- Joined: Sun Sep 20, 2020 7:39 pm
- Location: Chattanooga, TN
Re: 1010 Crawler Loader no start after using jump box
That was it! Removing the starter and putting it back in did the trick. Thanks!
196x JD 1010 Crawler Loader
Who is online
Users browsing this forum: No registered users and 94 guests