General help and support for your Lindeman through 2010 John Deere crawler
2 posts • Page 1 of 1
I am rebuilding the right side final drive. have all the parts thanks to Lavoy Wilcox. I would like to know on the (clutch pressure plate) P/N #AT11853T. is there a tool or gauge to set the spring on it to specification. I have also install #7-facing plates p/n #M3293T and #6- driving plates M872T. NOTE- "I am a city folk so be nice" LOL Thanks for all your help !
Contact Lavoy. He normally has the gauge (JD7) to set the pressure plate fingers with, in stock. Lavoy posted a copy of the JD service bulletin about using the gauge to set the fingers on the FAQ board. It is the second one down on the page.
Who is online
Users browsing this forum: No registered users and 12 guests