General help and support for your Lindeman through 2010 John Deere crawler
-
Digger SR
- 420 crawler
- Posts: 36
- Joined: Sat Oct 31, 2009 2:20 am
- Location: La Crosse WI 54601
Post
by Digger SR » Wed Dec 29, 2010 10:38 am
Had to replace the bull gear recently...thanks Lavoy. After looking around at a few bull gears tooth count..55 and 56, and was wondering how they are put on? I have my old one at 55 with a cracked center hub and was wondering if i should keep it around just in case. Is it posible if one can not locate one, to buy a 56 tooth for the hub and just replace the gear on it with a 55 tooth?
Thanks
Jeff
440 IC #448161 W/Henry loader, 3020 D, #8 mower
-
Lavoy
- Site Admin
- Posts: 11108
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Wed Dec 29, 2010 5:55 pm
At one time I had new bull gear centers available, have not checked lately to see if I can still get them. At any rate, yes the center or the ring can be changed.
Lavoy
-
430WLPG
- 40C crawler
- Posts: 12
- Joined: Mon May 02, 2005 6:41 pm
- Location: Sw Okla.
Post
by 430WLPG » Wed Dec 29, 2010 9:13 pm
Lavoy is the center hub the same in both the 55 and 56 tooth bullgears
-
Lavoy
- Site Admin
- Posts: 11108
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Thu Dec 30, 2010 9:59 am
Yes it is, however, there are two different centers, light and heavy. There is no part number difference, it is just a running change that Deere made because of cracking in the hub.
Lavoy
Who is online
Users browsing this forum: No registered users and 19 guests
