40c Fuel cap
-
- 440 crawler
- Posts: 223
- Joined: Sun Oct 27, 2013 8:41 am
- Location: Saint John, NB, Canada
40c Fuel cap
Just received an original type high fuel cap for my crawler. It won't fit down through the hole in the hood to go on the tank. My tank might be off a Model M. Would that make a differnce? I was thinking the 40 tank might have a taller neck to come up through the hood so the cap would go on.
have 40c 4 roller crawler, 1927 Ford T Touring car, 1931 Ford A Roadster, 1951 Standard Vanguard Saloon. Never a dull moment!
See if your tank is bent in a little, the neck should be above the hood enough to get the cap on.
Lavoy
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
-
- 440 crawler
- Posts: 223
- Joined: Sun Oct 27, 2013 8:41 am
- Location: Saint John, NB, Canada
Thanks Lavoy. I'll check it out. Maybe I should use rubber grommets to lift the tank a bit. I see them in the M parts book but not in the 40 parts book. Were they used on the 40 as well?
have 40c 4 roller crawler, 1927 Ford T Touring car, 1931 Ford A Roadster, 1951 Standard Vanguard Saloon. Never a dull moment!
Normally don't see them on 40's. I have had a couple tanks that have had a branch or something fall on them and push the neck down so it is hard to get a cap on.
Lavoy
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
Who is online
Users browsing this forum: No registered users and 65 guests