General help and support for your Lindeman through 2010 John Deere crawler
-
hokster
- 40C crawler
- Posts: 23
- Joined: Fri Dec 13, 2013 7:37 pm
Post
by hokster » Sat Feb 01, 2014 1:36 pm
hey guys i cleaned up the steering clutches to left side and put back together. it worked great for a few minutes now there is no power to that track. i put blade against a snow bank and only right track will turn. is this a adjustment problem. need advice
-
hokster
- 40C crawler
- Posts: 23
- Joined: Fri Dec 13, 2013 7:37 pm
Post
by hokster » Sat Feb 01, 2014 3:45 pm
When i say only right track turns I mean the right track has power left track turns freely but no drive to it.
-
Gil
- 1010 crawler
- Posts: 362
- Joined: Fri Dec 14, 2007 3:19 pm
- Location: Pennsylvania
Post
by Gil » Sat Feb 01, 2014 7:16 pm
You can not clean up fiber steering clutch plates - you can replace them. Gil
JD440-ICD loader; JD440-IC bulldozer; JD440-ICD backhoe; JD440-I backhoe; JD440-I tractor; + five recumbent JD440-ICs
-
hokster
- 40C crawler
- Posts: 23
- Joined: Fri Dec 13, 2013 7:37 pm
Post
by hokster » Sat Feb 01, 2014 8:20 pm
fiber disc are fine steel disc had light rust. over looked adjusting throw out bearing. going to try that tomorrow
-
jtrichard
- 350 crawler
- Posts: 1883
- Joined: Sun Jan 11, 2009 9:48 pm
- Location: Joshua Tree CA
Post
by jtrichard » Sun Feb 02, 2014 12:53 am
yes its adjustment
2010 with 622 dozer with mod. 35 ripper and a 2010 with 622 dozer bought in 1969 and a 2010 loader with drott and mod. 36 ripper
-
hokster
- 40C crawler
- Posts: 23
- Joined: Fri Dec 13, 2013 7:37 pm
Post
by hokster » Mon Feb 03, 2014 5:10 pm
Thanks for the help guys it was a throw out bearing adjustment
Who is online
Users browsing this forum: No registered users and 147 guests