A couple of my roller grease fittings squeeze the grease back out of the zerk. Are these bad zerks that need to be replaced or is there a larger internal roller problem? Where to get new zerks if that's the problem?
1966 diesel 350, 5 roller.
Thanks
350 roller grease fitting
- Stan Disbrow
- 350 crawler
- Posts: 2904
- Joined: Fri Jul 15, 2005 3:13 pm
- Location: Raleigh, NC
Re: 350 roller grease fitting
Hi,
The zerk has a ball right at the opening with a spring behind it. When the spring gets weak, it leaks. The thing is built such you can't fix it. So, you just replace it.
Stan
The zerk has a ball right at the opening with a spring behind it. When the spring gets weak, it leaks. The thing is built such you can't fix it. So, you just replace it.
Stan
There's No Such Thing As A Cheap Crawler!
Useta Have: '58 JD 420c 5-roller w/62 inside blade
Useta Have: '78 JD350C w/6310 outside blade
Useta Have: '68 JD350, '51 Terratrac GT-25
Have: 1950 M, 2005 x495, 2008 5103 (now known as 5045D)
Useta Have: '58 JD 420c 5-roller w/62 inside blade
Useta Have: '78 JD350C w/6310 outside blade
Useta Have: '68 JD350, '51 Terratrac GT-25
Have: 1950 M, 2005 x495, 2008 5103 (now known as 5045D)
Re: 350 roller grease fitting
Ok I'll check out Napa
Thanks
Thanks
Who is online
Users browsing this forum: No registered users and 19 guests