General help and support for your Lindeman through 2010 John Deere crawler
-
justjd420
- 40C crawler
- Posts: 24
- Joined: Sat Mar 01, 2008 5:05 pm
- Location: Rome, New York
Post
by justjd420 » Tue Apr 29, 2008 6:41 pm
are the tightening nuts for the front idle wheel for this crawler held in place by a screw located on top of the nut?? Im not talking about the tension nuts for the track tension.
-
bkrr
- 40C crawler
- Posts: 13
- Joined: Tue Mar 11, 2008 7:50 pm
- Location: Shushan NY
Post
by bkrr » Thu May 01, 2008 5:35 pm
are you talking about the nuts that hold the axle for the front idler. I dont think they have a set screw in the nut however there is one listed a 22h-712 but I will check my machine that is 420c five roll. and advise accordingly. hope this helps. bkrr
-
Lavoy
- Site Admin
- Posts: 11108
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Thu May 01, 2008 6:43 pm
There is a set screw that holds the axle from rotating, but there are no set screws on the nuts themselves.
Lavoy
Who is online
Users browsing this forum: No registered users and 2 guests
