420c right steering lever is sloppy.
- jdjohng
- 40C crawler
- Posts: 16
- Joined: Mon Oct 03, 2005 6:52 pm
- Location: Upper Penninsula of Michigan
420c right steering lever is sloppy.
The right steering lever on my 420c is sloppy where it goes into the housing causing it to sit at a little different angle than the left one. It steers good but I know something is wrong in there. Any ideas?
-
- 1010 crawler
- Posts: 305
- Joined: Mon Apr 04, 2005 7:01 pm
- Location: Gloucester,Virginia
$20 lever
Hi,
There is a bushing in the clutch housing.If the bushing is gone then it will be real sloppy.If you use it that way long enough then the housing and
shaft will be damaged.If remove the lever you may be able to install
a new bushing.The JD part number is M 1638 T.Hope this helps
you fix the problem.JimAnderson
There is a bushing in the clutch housing.If the bushing is gone then it will be real sloppy.If you use it that way long enough then the housing and
shaft will be damaged.If remove the lever you may be able to install
a new bushing.The JD part number is M 1638 T.Hope this helps
you fix the problem.JimAnderson
Who is online
Users browsing this forum: No registered users and 82 guests