Valve cover gasket

General help and support for your Lindeman through 2010 John Deere crawler
Post Reply
crawler440ic
MC crawler
MC crawler
Posts: 1
Joined: Wed Nov 05, 2008 9:33 pm
Location: Washington

Valve cover gasket

Post by crawler440ic » Thu Nov 06, 2008 10:14 am

I recently purchased a 1958 440ic with loader. I am doing some maintenace on it and need to replace the valve cover gasket and the grommet that the bolt goes through to hold the valve cover on. Where would I get these items. Do I need to make my own gasket? Also, where is a good place to get a rebuild kit for my carb, TSX-768? Thanks
Top
User avatar
hunter41mag
440 crawler
440 crawler
Posts: 126
Joined: Tue Apr 12, 2005 7:11 am
Location: Eastern Pennsylvania (NE of Allentown)

Post by hunter41mag » Thu Nov 06, 2008 2:51 pm

Look on this website by clicking on "Parts Listings". Carb kits are listed but I did not see valve cover gaskets/grommets. Says to call Lavoy for individual engine parts. His number is at the bottom left of the parts page or send him a pm.
Don
Eastern PA
440IC (1960)
Top
User avatar
Lavoy
Site Admin
Site Admin
Posts: 11127
Joined: Sun Apr 03, 2005 8:32 pm
Location: North Dakota
Contact:
Contact Lavoy

Post by Lavoy » Fri Nov 07, 2008 8:46 pm

I am currently out of stock on 440 carb kits, should have more in the middle of next week. I may have one of the gaskets for the bolt, you can also use a larger diameter o-ring in a pinch.
Lavoy
Top
Post Reply

Return to “Early model JD crawler technical support”

Who is online

Users browsing this forum: No registered users and 13 guests