I want to confirm that they are positive ground from the factory?
And also does this mean that I hook the wire from the on switch to the positive post or to the negative post? I am confused since that is actually negative if it is a positive ground. When I have it setup with the wire from the start switch to the neg post I read neg 6volts on the coil. Then the other side terminal on the distributor goes to the negative terminal on the coil correct?
Also I got a new cap, rotor, and wires from lavoy. I notice that the rotors center contact rides on a plastic bump inside the distributor cap. Is something else supposed to go in between to make the contact or is this space there intentionally?
It looks like the timing is close as the arm closes when it nears the pickups but I am just not getting spark. Very frustrating.
I am getting ready to go 12 volt standard but I just would like to hear it run since it hasn't in almost 2 years now.
I am picking up a new coil today (2nd one) and hopefully a new capacitor for the dist internals if I can find one but any help you guys can give me will really help out. I'm stuck!
![Smile :)](./images/smilies/icon_smile.gif)