Parts, Services, and For-Sale
-
Pat
- 440 crawler
![440 crawler 440 crawler](./images/ranks/wrench/spanner_rank_2.gif)
- Posts: 144
- Joined: Thu Dec 08, 2005 9:14 am
- Location: Jacksonville NC
Post
by Pat » Thu Feb 23, 2012 6:41 pm
-
ktheaker
- 430 crawler
![430 crawler 430 crawler](./images/ranks/wrench/spanner_rank_1.gif)
- Posts: 84
- Joined: Sat May 01, 2010 8:56 pm
- Location: ontario canada
Post
by ktheaker » Sat May 26, 2012 4:45 am
the atatchment points on the dozer are included with this setup ? the 1010 that i have just has a push manual blade and i am showing some interest in the set- up and just asking is there anything missing that i require to install on the frame
kt
-
JD440ICD2006
- 350 crawler
![350 crawler 350 crawler](./images/ranks/wrench/spanner_rank_5.gif)
- Posts: 1113
- Joined: Tue Aug 22, 2006 3:57 pm
- Location: South Carolina
Post
by JD440ICD2006 » Sat May 26, 2012 5:46 am
Curious, how are the ends that connect to the blade of the the angle cylinders (two in the middle of pic) held on? Are they screwed on or spun welded?
Thanks,
1959 JD 440ICD w/64 Power Angle Tilt Blade
1959 JD 440ICD w/63 Manual Angle Blade
1959 JD 440IC w/602 Manual Angle Blade
1959 JD 730D W SE (many options)
1950 JD M S w/M-20 Mower
1952 JD M W
1955 FORD 640 (burns the most fuel)
-
Lavoy
- Site Admin
![Site Admin Site Admin](./images/ranks/wrench/spanner_rank_5_admin.gif)
- Posts: 10957
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Sat May 26, 2012 4:06 pm
They are threaded on.
Lavoy
-
ktheaker
- 430 crawler
![430 crawler 430 crawler](./images/ranks/wrench/spanner_rank_1.gif)
- Posts: 84
- Joined: Sat May 01, 2010 8:56 pm
- Location: ontario canada
Post
by ktheaker » Sat May 26, 2012 6:24 pm
are the hydrolic pumps the same for the 1010 non angle blade as the hydrolic angle blades - the pumps are the same out put ? and the lines are all that is nec to change up or was the pump a higher output ?
kt
-
Lavoy
- Site Admin
![Site Admin Site Admin](./images/ranks/wrench/spanner_rank_5_admin.gif)
- Posts: 10957
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Sun May 27, 2012 9:57 am
Pump is the same, valve and all the lines are different.
Lavoy
Who is online
Users browsing this forum: No registered users and 17 guests