350C Stiff Clutch

Post support questions about your JD350 and newer crawler here
Post Reply
sullyt28
420 crawler
420 crawler
Posts: 45
Joined: Thu May 23, 2013 6:59 pm

350C Stiff Clutch

Post by sullyt28 » Wed Jul 17, 2013 6:53 pm

The clutch on my 350C is extremely stiff. Owner prior I don't believe ever uesd it. I put an extra spring on the pedal to try to get it to return to the home position, didn't do much. Just wondering if anyone else has experienced this and suggest a possible fix ?

The clutch does work fine, you just have to reach down with your hand to pull it back to the home position. Im hoping if I use it more on a regular basis it may correct itself :wink:
Sully
Barrie, ON

User avatar
Lavoy
Site Admin
Site Admin
Posts: 11116
Joined: Sun Apr 03, 2005 8:32 pm
Location: North Dakota
Contact:

Post by Lavoy » Wed Jul 17, 2013 9:42 pm

The clutch pedal pivot is rusty, need to free it up somehow. Pull the platform, it will be easier to see.
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com

sullyt28
420 crawler
420 crawler
Posts: 45
Joined: Thu May 23, 2013 6:59 pm

Post by sullyt28 » Thu Jul 18, 2013 5:01 am

I thought that as well. I pulled the plates and applied a degreaser (there was evidence dirt/grease etc ) I than pressure washed the area. Next I used a fluid film hoping that it would creep and hopefully free it up. No luck.

The way it is designed it doesn't sound like anything internal could make the clutch stiff ?

I was hoping someone else had a similar condition and what they had done to get it to free up. Maybe try heat ?
Sully
Barrie, ON

User avatar
Lavoy
Site Admin
Site Admin
Posts: 11116
Joined: Sun Apr 03, 2005 8:32 pm
Location: North Dakota
Contact:

Post by Lavoy » Thu Jul 18, 2013 10:01 am

Real pain in the ass to work on, not even enough room to get the pedal off I don't think. You can try and drill an oil hole, or use a drive in grease zerk to get some grease in there. If you could move the pedal out even a little, you might be able to clean the rust off the shaft some.
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com

Post Reply

Who is online

Users browsing this forum: No registered users and 9 guests